โฐ MonโFri
10:00 AM โ 5:00 PM (EST)
โ๏ธ support@switchprince.com
๐ Ships from the United States
Photocell Sensors
A photocell sensor switches a lamp on when it gets dark and off again at daylight, so a lamp post, lantern or porch fixture runs only when it is needed. These Zing Ear photocell switches are small enough to sit inside a lamp post or lantern, and they come with leads, wire connectors and wiring instructions.
Most of the choosing comes down to two things: how many wires the sensor has, and how much load it has to switch. The table compares every model in this category.
Model
Wiring
Load rating
Lamp types
Mounting hole
SNR-500RY
3-wire
120V, 250W max
LED, incandescent, fluorescent, halogen
3/8 in
SNR-250RY
3-wire
120V, 250W incandescent/halogen, 60VA LED
Dimmable LED, incandescent, halogen
3/8 in
SNR-250RY-2
3-wire
120V, 250W incandescent/halogen, 60VA LED
Dimmable LED, incandescent, halogen
3/8 in
SNR-100WF
3 leads (white, black, red)
120V, 100W max, 39VA
Incandescent, halogen, dimmable CFL, dimmable LED
7/16 in
SNR-100W
2 leads (white, black)
125V, 0.8A, 100W
Incandescent, halogen
7/16 in
Before you order, check: โข Wire count. Count the leads on the sensor you are replacing. A 2-lead photocell and a 3-lead photocell are wired differently, so they are not interchangeable without rewiring. โข Load. Add up the wattage of the bulbs on the circuit and stay under the sensor rating. LED loads are rated in VA on some models. โข Lamp type. Some models are for incandescent and halogen only. Check that the model you pick lists your bulb type. โข Mounting hole. Measure the hole in your post or fixture. The sensor eye needs a 3/8 in or 7/16 in hole depending on the model. โข Power off first. Turn off power at the breaker before touching any wiring, and use a qualified electrician if you are unsure.