Customer Service

 

 

โฐ Monโ€“Fri
10:00 AM โ€“ 5:00 PM (EST)
โœ‰๏ธ support@switchprince.com
๐Ÿ“ Ships from the United States

Zing Ear ZE-109 and ZE-109M Wiring Diagram

Wiring diagram and instructions for the Zing Ear ZE-109 and ZE-109M, 2 wire on/off pull chain light switches for ceiling fan lights and lamps. Both switches are wired the same way.

Safety: turn off the electrical current at the source by turning off the circuit breaker. Skipping this step can cause electric shock, fire, serious injury or death.

Check your old switch first. This wiring diagram is for light switches where:

  • The switch has 2 wires.
  • The function is on/off.

If your old switch has 3 wires, these wiring instructions will not work. You need a 3-wire switch such as the Zing Ear ZE-110. See all 2 wire light switches.

Switches this wiring diagram covers

SwitchDetails
Zing Ear ZE-109Plastic housing. View the ZE-109
Zing Ear ZE-109MMetal housing. View the ZE-109M

ZE-109 and ZE-109M 2 wire switch

Zing Ear ZE-109 and ZE-109M 2-wire pull chain light switch diagram

How to wire the ZE-109 and ZE-109M

  1. Turn off the electrical current at the source by turning off the circuit breaker. Failure to disconnect power may cause fire, electric shock, serious injury or death.
  2. Make sure the existing light switch has 2 wires. If it has 3 wires, a 3-wire switch is required.
  3. Cut the two wires from the existing light switch using a wire stripper.
  4. Strip about 1/2 inch of insulation from the black wires.
  5. Connect one black wire from the light switch to one black wire from the ceiling fan.
  6. Connect the other black wire from the light switch to the other black wire from the ceiling fan. Secure each connection with a wire connector by twisting it clockwise. Loose connections can cause fire, electric shock or serious injury.

Wiring diagram for lighting fixtures

Wiring diagram for a 2-wire pull chain light switch in a lighting fixture: hot wire through the switch to the lamp, neutral wire to the lamp

Questions about the ZE-109 and ZE-109M

How do I wire a Zing Ear ZE-109 or ZE-109M?

Turn off the breaker, then connect one black wire from the switch to one black wire from the fan or fixture, and the other switch wire to the other black wire. Secure both connections with wire connectors, twisting them clockwise.

Are the ZE-109 and ZE-109M wired the same way?

Yes. Both are 2 wire on/off pull chain switches, so one wiring diagram covers both. The ZE-109 has a plastic housing and the ZE-109M has a metal housing.

Does it matter which wire goes where?

A 2 wire on/off switch has no numbered terminals. Connect one switch wire to each of the two black wires, the same way your old switch was connected.

Can I use the ZE-109 or ZE-109M to replace a 3-wire light switch?

No. If your old switch has 3 wires, you need a 3-wire switch such as the Zing Ear ZE-110.

Can I use these switches for a lamp as well as a ceiling fan light?

Yes. The switch goes in the hot (black) wire between the power supply and the lamp, as shown in the wiring diagram for lighting fixtures above.

Leave a Reply

Your email address will not be published. Required fields are marked *

What Our Clients Say
54 reviews